You are browsing camaro6 
09-23-2024, 04:58 PM
|
#1 |
 
Drives: 2017 2SS 50th H/C Join Date: Feb 2022
Location: CT
Posts: 8
|
Radiator fan stuck on after heads/cam
After i did a heads, cam, fbo setup on my 6th gen camaro ss the fan immedietly kicks on low and then a few seconds later ramps up to full blast even on cold start. AC is off. Ive tried switching the relay, unplugging everything plugging it back in, disconnecting the battery nothing seems to fix it. I know its not tune related because it started doing it even before it was tuned. (I ran the car after I finished the job at idle just to make sure all was well.) I am running a katech 174 thermostat but that was tuned in with hp tuners. Also it does it immediately way before the thermostat even opens. Any suggestions would be greatly appreciated!!!
__________________
50th Anniversary Camaro, 1 7/8 headers, lt2 IM, CAI CAI, Frankenstein ported/milled heads, Cam Motion Custom Cam, 3 In Middle, Borla atak mufflers, GPI tuned.
|
|
|
|
Yesterday, 10:32 AM
|
#2 |
|
Petro-sexual
|
Any DLCs?
__________________
 '20 ZL1 Black "Fury" A10, PDR, Exposed CF Extractor Magnuson Magnum DI TVS2650R // RFBG // Soler 103 // TooHighPSI Port Injection // THPSI Billet Lid // FF // Katech Drop-In // PLM Heat Exchanger // ZLE Cradle bushings // BMR Chassis-Suspension Stuff // aFe Bars // Diode Dynamics LEDs // ACS Composites Guards // CF Dash // Aeroforce // tint // other stuffs |
|
|
|
|
|
|
|
|
Post Reply
|
| Tags |
| cooling, fan, help needed, thermostat, tstat |
|
|
